Hem » Multirotor » Flightcontroller / PDB / LC » F4 Race Cube combo

F4 Race Cube combo


Weight: Approx 8.5g

Omnibus F4

With MPU6000 (6DOF Version) & SPI Connection
With 128Mb Flash(16M Byte) Blackbox
Onboard 5V/1A BEC (Output)
Onboard OSD
Weight: 3,3g
Size: 27x27mm
Mounting: 20x20mm (M2.5)
Factory said they use M2 Nylon Spacer & Screw
Default Firmware: betaflight_3.1.0_OMNIBUSF4
could be changed from time to time
Onboard LC Filter
Input Voltage: 2-4S Li-Po
Support DSHOT
Set RX1 as connection port when SBUS/DSM is used
DMS uses 3.3V
SBUS/PPM uses 5V
Support Buzzer / LED
Support BLHELI ESC Programming
Support Cleanflight & BetaFlight


Firmware: BLHELI_S
Voltage Input: 2-4S LiPo/2-4S HV LiPo
BEC: None
Current: 10A (15A Peak @ 5 seconds)
Size: 27x27mm
31*3.15mm Included Soldering Pads
Mounting: 20x20mm (M2.5 Hole)
Weight: 3.6g
DSHOT, OneShot Supported


Use RX1 as port when using SBUS & DSM
DMS uses 3.3V Port
SBUS & PPM use 5V Port

Package Included

1 x F4 Omnibus Fight Controller
1 x 10A 4-in-1 ESC

Note: M2 Nylon Spacers are used on these boards. So you may need to get some M2 size spacers and screws.

** Warning: The default firmware shipped with the board has been tested and configured by the factory in working condition (factory flashed the board with tested firmware manually via USB). You will be responsible for damage (or any part of function not working) if you flash your own firmware. So you are recommended to use the default firmware which shipped with the board. Thank you for your understanding.

** Warning: You must be very be careful when you do soldering on this ESC because it is small. All IC components on this board are tiny so the soldering iron/gun might damage the ICs if it is overheat. So you must have good soldering skill (fast & clean) to do this job properly.


Fabrikat: RC
Artnr: Bild: Benämning: Lager: Pris: Antal:
RCX08-01 I lager
439,00 kr